No products in the cart.
A strain gauge made entirely on a PCB 13
A strain gauge made entirely on a PCB
A strain gauge made entirely on a PCB
by u/Trypocopris in electronics
Skip to navigation Skip to content
Awww I wanted them to make it go ntrrr
Nice did you Open source it ?
I am intressted in the Layout i work a lot of with this Sensors
very cool
verz cool. How do you do it? Measure the capacity?
YOU DIDN’T GIVE IT THE RULER TREATMENT
Very interested, is the board design opensource?
It’s much better with sound: [https://www.youtube.com/watch?v=dQw4w9WgXcQ](https://www.youtube.com/watch?v=dQw4w9WgXcQ) .
You made a load cell. Electronic scales use very similar components to measure weight. Cool to see it on a PCB like this though!
The ‘diving board’ might be better if it was tapered from wide at the point of attachment to narrower at the end, so that the bending it distributed rather than mostly at the point of attachment. But very cool!
So simple yet so awesome. Did you custom make the PCB?
Take my upvote!
aaaaahhh flick it already
Do you plan on making it opensource? It would be great!